Lefant Nautica Hard Eco Dark Blue 2,5L

Nautica Hard Eco is a new and innovative addition to Lefants biocide free bottom paint range, suitable for sailing and motorboats in all ranges of speed. The hard matrix contributes to reduce friction and increased speed, as well as reducing fuel consumption. Nautica Hard Eco protects the boat against fouling and gives a surface that is easy to keep clean. Also suitable and safe for use on aluminium hulls and can be applied directly on a wide range of existing coatings.
Compatibility: Direct over Lefant Mark 5, TF, Nautica Copper and most of other hard and semi hard solventbased antifoulings.
Colors: Dark Blue, BlackCoverage: 13m²/literFinish: MatteVolume Solids: 50 ±2% (ASTM D2369)Flash Point: 30°CSpecific Gravity: 1,44 (ISO 2811-1)Shelf Life: 2 years (min)VOC: 430g/l (ISO 11890-2/2006)Unit Size: 750ml, 2500ml PRODUCT DATAColors: Dark Blue, BlackCoverage: 13m²/literFinish: MatteCompatibility: Direct over Lefant Mark 5, TF, Nautica Copper and most of other hard and semi hard solventbased antifoulings.Volume Solids: 50 ±2% (ASTM D2369)Flash Point: 30°CSpecific Gravity: 1,44 (ISO 2811-1)Shelf Life: 2 years (min)VOC: 430g/l (ISO 11890-2/2006)Unit Size: 750ml, 2500ml
APPLICATION DATAApplication: Brush, RollerCoverage: 13m²/literFilm Thickness: 40-60µ (dry)Number of Coats: 2 coats for seasonal protection. Extra coats in areas where the fricton and wear are higher, such as rudder, stem, waterline.
APPLICATION INTERVALTemperature - 10°C Min - 20°C Min/MaxOvercoating - 10h - 6hLaunching - 24h - 12h/2 mth.
Conditions during application: Do not paint in wet or humid conditions. The substrate temperature should not understep +5°C during the application and 6 hours after the job is done. Drying times and overcoating intervals will increase with thicker paint layers. When applying in confined spaces, make sure the area is sufficiently ventilated.
SURFACE PREPARATIONSSurface in good condition: Remove all traces of loose paint and contamination by sanding the entire surface well with 80 grit sandpaper. Remove sanding debris.
Surface in poor condition: Completely remove all old antifouling paint using Lefant Paint Remover or by sanding or sandblasting to near base surface.
Surface of BARE Gelcoat/GRP: It is very important that bare gelcoat/GRP be properly prepared. Remove mold release wax using Lefant Boat Cleaner concentrated followed by using Lefant IPA Surface Cleaner.Sand the surface rough (grit 80)and fill any surface imperfections withLefant Epoxi Filler following the label instructions. Apply at least one layer of Lefant Epoxi Primer by following label instruction.